If your tread depth is less than 2/32 inches it's time to replace your tires - Tires are legally worn out and need to be replaced when they reach 2/32nd of remaining tread depth. When there is 2/32nds of an inch left, the tires are legally worn out, or bald. When you drive on tires, the tread gradually wears down. All-terrain or mud tires have a deeper tread. Most passenger car tires have a tread depth of around 10/ 32nds of an inch when new. Here are some troubleshooting tips to determine if you should replace your tires. As a rule of thumb, tires should be replaced if your tread depth is less than 2/32 inch, but this is not always the case. Light truck tires have deeper tread than car tires when new. The tread depth on a new tire various on the brand and style of tire. It will give you peace of mind that are your tires are still in good condition. It just takes a minute to see if your tires are ready to be replaced using the penny test or to check with a tread depth gauge. You could also get ticketed during a routine traffic stop. As well, if your tires are worn or bald, they are more susceptible to puncture and damage resulting in a flat. Worn tires affect the control and handling of your car and your safety. If the reading shows less than 3 or 4/32nds of an inch, it is time to replace the tires for maximum safety. The probe in the barrel of the gauge will indicate the tread depth reading. To use a tire gauge, place the end of the probe into a tread groove, pressing down on the base of the gauge until it is seated flat against the tread block. Use a tread depth gauge to measure tire tread depth - this tool is more precise. If you can see all of Lincoln's head, your tire needs to be replaced. Insert a penny, with Lincoln's head facing down, into the tire tread groove. To choose new tires, please refer to Giga's Tire Buying Guide for articles on our best sellers and customer favorites. When the tread wear bar becomes flush with the top of the tread, it's time to replace the tires. It's a small rubber bar at the bottom of the tire tread grooves. In some locations, they may also no longer legally qualify as winter tires.The first and easiest way to check tire tread depth is to look for the tread wear indicator bar. If they are flush with the level of the tread, the tire is no longer suitable for winter driving conditions. Several winter tire models are equipped with winter tire wear indicators. If they are flush with the level of the tread, then the tire should be replaced. Tread wear indicators, or wear bars, are spaced evenly through the main grooves in the tire tread. Therefore, check your tires regularly, reduce your speed on wet and snowy roads and consider replacing your tires in good time.Įnsure your vehicle is equipped with the correct winter, summer, or all-season tires. On wet roads there is an additional increased risk of aquaplaning with fading tread depths. On wet or snow-covered roads braking performance will progressively decline with lower tread depths. Please consider that safe driving in wet and snowy weather conditions is affected by the tread depth, the pattern design and the rubber compound of the tread of your tires. These tires are not safe for driving and must be replaced. Braking distance and vehicle control are impaired. A tire with a tread depth below 1.6 millimeters (2/32 inches) lacks grip. New tires have an average tread depth of 8 to 9 millimeters (10/32 to 11/32 inches). Tread is the rubber on the tire that touches the road. To ensure your safety, measure the tread depth as part of your regular vehicle maintenance. Shallow tread grooves make it harder to control the vehicle in wet weather and the chance of aquaplaning increases. But if it's not deep enough, your car loses traction and suffers extended braking times. Your tires form the essential bond between your vehicle and the ground.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |